Transmission Position Sensor/Switch: Adjustments

TRANSAXLE RANGE SWITCH ADJUSTMENT
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct, and air cleaner assembly.
3. Remove the spring pin and clip and disconnect the selector cable.
4. Rotate the manual shaft to N position.
5. Disconnect the transaxle range switch connector.
6. Loosen the transaxle range switch mounting bolts.

Connect An Ohmmeter Between Terminals (A) And (H):

7. Connect an ohmmeter between terminals (A) and (H).
8. Adjust the switch to the point where there is continuity between the terminals.

Tighten The Transaxle Range Switch Mounting Bolts:

9. Tighten the transaxle range switch mounting bolts.

Tightening torque: 7.9-1O.7 Nm (70-95.4 in.lbs.)

10. Verify that the selector lever range position and trans- axle range switch are aligned.
11. Connect the transaxle range switch connector.
12. Connect the selector cable and install a new spring pin and clip.
13. Install the air cleaner assembly, fresh-air duct, and resonance chamber.