Ignition Coil Pack: Service and Repair

IGNITION COIL PACK REMOVAL / INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order shown in the figure, referring to Removal Notes.
3. Install in the reverse order of removal, referring to Installation Notes.

Coil Packs:

1. Ignition coil pack.

Ignition Cable Clips (at Coils):

REMOVAL NOTES
1. Disconnect the ignition cables from the coils by squeezing the locking tabs on the cable by hand. Use a twisting and pulling motion to remove the cables from coils. DO NOT PULL ON THE CABLE.
2. Disconnect the harness connector from the coils.
3. Remove the screws and remove the coils.

INSTALLATION NOTES
1. Mount the ignition coil to its bracket and install screws.

Tightening torque 5-7 Nm (44-66 in. lbs.)

2. Reconnect engine harness electrical connector to the ignition coil.
3. Insert each lead on the proper terminal of the ignition coil. Make sure that the coil boots are fully seated and both locking tabs are engaged.

Coil Packs With Cable Locations:

NOTE: The terminals are identified on the ignition coils. Install wires as shown in the illustration. The firing order is 1-3-4-2 for both ignition coil packs.