Component Tests and General Diagnostics
CRANKSHAFT POSITION SENSORResistance Inspection
1. Disconnect the crankshaft position sensor connector.
2. Measure the resistance between terminals A and B by using an ohmmeter.
Specification: 950-1,250 (1,100 ± 150) Ohms
3. If not as specified, replace the crankshaft position sensor.
Air Gap Inspection
1. Measure the air gap between the crankshaft pulley and the crankshaft position sensor by using a feeler gauge.
Specification:
0.5-1.5 mm (0.040-0.080 in)
2. If not as specified, replace the crankshaft pulley or the crankshaft position sensor.
NE signal illustration
NE Signal (Warm Idle No Load):
- After warm-up idle with no load condition.