Transmission Position Sensor/Switch: Adjustments

Adjustment




1. Remove the selector rod from the manual shaft lever.
2. Move the manual shaft to the N position.
3. Loosen the transaxle range switch mounting bolts.




4. Align the holes of the transaxle range switch and the manual shaft lever by inserting a pin with an outer diameter of approx. 4.0 mm (0.157 in).




5. Tighten the transaxle range switch mounting bolts and remove the pin.

Tightening torque: 2.5-3.9 Nm (22-34 in-lb)

6. Recheck the continuity of the transaxle range switch.
7. If not correct, replace the transaxle range switch.
8. Install the selector rod to the manual shaft lever.