With Manual Transaxle

OBD-II System Check:

OBD II DRIVE CYCLE PROCEDURE

NOTE:
- Disconnecting the battery will reset the memory. Do not disconnect the battery during and after this procedure.
- Vehicle speed and engine speed detected by the Powertrain Control Module (PCM) may differ from that indicated by the speedometer and the tachometer. Check the vehicle speed and engine speed during driving mode by using the SST NGS.
- If the OBD II system check is not completed while the drive cycle procedure is carried out, the following cause is guessed.
1. The OBD II system detects the malfunction.
2. The drive cycle procedure is not completed correctly.

Graph Of Drive Mode - 1:

MODE 1
1. Start the engine and warm it up completely.
2. Verify that all electrical loads (headlight, blower motor and rear window defroster) and A/C load are off.

NOTE: Driving mode before the constant speed driving is not specified.

3. Drive the vehicle at the constant speed of 84-93 km/h (52-58 mph) for one minute.

Graph Of Drive Mode - 2:

MODE 2
1. Start the engine and warm it up completely.
2. Verify that all electrical loads (headlight, blower motor and rear window defroster) and A/C load are off.
3. Drive the vehicle at the constant speed of above 65 km/h (40 mph) for one minutes after the above 300 seconds from engine start.
4. Drive the vehicle at the constant speed of 65-96 km/h (40-60 mph) for three minutes.

NOTE: Driving mode before the constant speed driving is not specified.