Disassembly

1. Measure the thrust clearance of all gears before disassembly, referring to Preinspection.
2. Disassemble in the order shown in the illustration, referring to the following notes:

Bearing (4th Gear End)
1. Support the primary shaft to keep it from falling.





2. Remove the 4th gear end bearing by using the Special Service Tool (SST).

3rd/4th Clutch Hub Assembly, 3rd Synchronizer Ring And 3rd Gear
1. Support the primary shaft to keep it from falling.





2. Remove the 3rd/4th clutch hub assembly, 3rd synchronizer ring, and 3rd gear by using the SST.





Bearing (Primary Shaft End)
Remove the primary shaft end bearing by using the SST.