Rear

1. Remove in the order shown in the figure.





NOTE: Turn the manual adjustment gear counterclockwise with an Allen wrench to pull the brake caliper piston inward. (Turn until it stops.)

2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal.





NOTE:
- Turn the manual adjustment gear clockwise until the brake pads just touch the disc plate.
- Return the manual adjustment gear 1/3-turn.

4. After installation, check the following.
a. Add fluid and bleed the air. Service and Repair
b. Check for fluid leakage.
c. Depress the pedal a few times, then verify that the brakes do not drag while rotating the wheel by hand.