With Automatic Transaxle

Replacement




1. Remove the undercover.
2. Remove bolt (A).
3. Remove bolt (B) and bracket.
4. Install in the reverse order of removal.

Tightening torque (A) (B): 7.9-10.7 Nm (80-110 kgf/cm., 70-95.4 in.lbs.)

5. Adjust the air gap.

Adjustment
1. Loosen bolt (A).




2. Adjust the air gap between the crankshaft pulley projection and the crankshaft position sensor by using a feeler gauge.

Specification: 0.5-1.5 mm (0.020-0.059 in.)

3. If not adjusted, replace the bracket and readjusted the air gap.
4. If not adjusted, replace the crankshaft pulley or the crankshaft position sensor.