Central Control Module: Testing and Inspection

1. Removal the scuff plate, front side trim, and hood release lever.
2. Remove the joint box mounting nut.
3. Cut away the vinyl tape stuck to the floor harness.
4. Follow the appropriate procedure, referring to the terminal voltage list.




Connector A
^ Remove the CPU from the joint box, then measure the voltage at the CPU terminals from the joint box side.




Connector B, C, and D (terminals 1B, 1M, 1N, 2D, 2T, and 3A)
^ Disconnect the CPU connector and check for continuity between the terminal of the CPU connector and ground.




Connector B, C, and D (Terminals except 1B, 1M, 1N, 20, 2T, and 3A)
^ Install the CPU onto the joint box and measure the voltage at the CPU terminals.

5. If not as specified, inspect the parts listed under "Inspection area" and the related wiring harnesses.
6. If the parts and wiring harnesses are okay but the system still does not work properly, replace the CPU.

Terminal Voltage List (Reference)




CONNECTOR A




CONNECTOR B




CONNECTOR C




CONNECTOR D