Closed Throttle Position Switch

1. Verify that the throttle valve is closed throttle position.
2. Disconnect the throttle position sensor connector.
3. Loosen the attaching screws.
4. Insert a feeler gauge between the throttle adjusting screw (TAS) and the throttle lever. By adjusting the throttle adjust screw (TAS), verify the continuity between the closed throttle position switch terminals C and D are as follows by using an ohmmeter.




Specification

5. Tighten the attaching screws.

Tightening torque
1.6 - 2.3 N.m {16 - 24 kgf.m, 14 - 20 in.lbf}

6. If not adjusted, replace the throttle position sensor.