Auto Control (Return Control)

With the auto switch tufted on, check that the steering wheel moves back to the position memorized by the computer (located inside the CPU) during manual control (i.e. the position before the ignition key was pulled out) after the ignition key is inserted and set it in the ACC position or ignition switch at ON. To solve faulty operation, follow the Diagnosis Chart.





NOTE:
^ This control stops operation when the following occur.
^ Auto switch is turned off.
^ Manual switch is turned on. Memorized position is reached.
^ Electric current flows to the motor for more than 10 seconds.
^ Position sensor movement speed is below the set value (1°56'04"/second).
^ In the initial state (when the battery is connected, or when the CPU is reset and there is no memorized position), the steering wheel returns to the neutral position.
^ The memorized position is updated every time adjustment is performed using manual control.