Using the SST (104 Pin Breakout Box)

1. Disconnect the PCM connector.




2. Connect the SST (104 Pin Breakout Box) to the PCM as shown.
3. Tighten the connector bolt.

Tightening torque : 7.9 - 10.7 N.m {80 - 100 kgf.cm, 69.5 - 95.4 in.lbf}

4. Warm up the engine to normal operating temperature.

Specification:

5. Measure the voltage at PCM terminals 35 and 60.

6. If not as specified, inspect the following.
- Intake-air system
- Fuel system
- On-board diagnostic system
- Related harnesses

7. If these systems are okay, replace the heated oxygen sensor.