Accelerator Pedal: Service and Repair

Table:

ACCELERATOR PEDAL REMOVAL/INSTALLATION [FS]
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.

Accelerator Cable Installation Note
^ Carry out the "ACCELERATOR CABLE ADJUSTMENT" procedure after installing the accelerator cable.

ACCELERATOR CABLE INSPECTION [FS]
1. Verify that the throttle valve is closed.

Note: To measure the cable free play, push the cable into the housing and put a white mark on the cable at the end of the housing. Then pull the cable out and measure distance from the white mark to the end of the cable housing.

2. Measure the free play of throttle cable.
^ If not within the specification, adjust the accelerator cable.
Free play: 1.5 - 4.0 mm (0.06 - 0.15 inch)