Detection Mode
INSPECTION OF DTCS FOR CONDITION DETECTION MODEUsing the Cruise Set Indicator Light
NOTE:
- The cruise set indicator light will illuminate for 3 seconds, when condition detection mode is on.
- If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruise set indicator light will not give a correct indication when you inspect the system. Use the SST (NGS set) to determine the cause of the malfunction.
1. Drive the vehicle at 16 km/h {10 mph} or more.
2. Operate each of the cruise control switches.
3. Stop the vehicle and let it idle.
4. Turn on the cruise control main switch (1).
5. Turn and hold the RESUME/ACCEL switch on for at least 3 seconds (2). The cruise set indicator light will illuminate for 3 seconds, and then go off for at least 2 seconds. Thus, the condition detection mode begins.
- If a DTC is indicated, inspect the corresponding system area.
- If normal, DTC(s) will not be indicated.
6. The condition detection mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.