12. Output Gear
OUTPUT GEARPreparation
SST
Disassembly/Assembly
1. Disassemble in the order shown in the figure, referring to Disassembly Note.
2. Assemble in the reverse order of disassembly, referring to Assembly Procedure.
Disassembly Note
Bearing
Remove the bearings from the output gear by using the SSTs.
Assembly Procedure
1. Press the new bearings onto the output gear by using the SST.
2. Apply ATF to new seal rings and assemble them to each side of the output gear.
Seal ring outer diameter: 36.6 mm (1.44 inch)