Front

SPEED SENSOR, FRONT (4X4) REMOVAL / INSTALLATION
Removal and Installation





1. Remove the rotor shield.





2. Disconnect the electrical connector.





3. Unclip the wire from the vehicle frame.





4. Remove the bolt.

Note: Plug the sensor mount opening and thoroughly clean the mounting surface. Apply High Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-19590-A meeting Mazda Specification ESA-M1C198-A.

5. Remove the front wheel speed sensor.
1 Remove the bolt and the sensor.
6. To install, reverse the removal procedure.