Precaution

Precaution
1. If the drive plates are replaced with new ones, soak the new part in ATF for at least 2 h before installation.
2. Before assembly, apply ATF to all seal rings, rotating parts, O-rings, and sliding parts.
3. All O-rings, seals, and gaskets must be replaced with new ones included in the overhaul kit.
4. Use petroleum jelly, not grease, during reassembly.
5. When it is necessary to replace a bushing, replace the subcomponent that includes that bushing.
6. Assemble the housing within 10 min after applying sealant, and allow it to cure at least 30 min after assembly before filling the transmission with ATF.

Warning: Although the stand has a self-locking brake system, there is a possibility that the brake may not hold when the transmission is held in a lopsided position on the stand. This would cause the transmission to turn suddenly, causing serious injury. Never keep the transmission tilted to one side. Always hold the rotating handle firmly when turning the transmission.