Carpet: Service and Repair

FLOOR COVERING REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:
1. Front seat
2. Rear seat
3. Joint cover
4. Front scuff plate inner
5. Rear scuff plate inner
6. Front side trim
7. Console panel
8. Console
9. B-pillar lower trim
10. Sub trunk box
11. Trunk end trim
12. Trunk side trim
13. Selector lever component.
14. Selector lever component bracket.
15. SAS control module.
16. Console bracket.






3. Cut away the floor covering as shown in the figure.

NOTE: The cut part does not need to match up when installing the floor covering.






4. Remove fastener A, B, and C.
5. Take the floor covering out from the opened liftgate.
6. Install in the reverse order of removal.