Procedures
Rear Drip Assembly NoteNOTE: If the rear drip is removed, butyl seal must be applied when re-installing.
1. Apply a 6.0-8.0 mm {0.24-0.31 in} wide line of butyl seal to the area shown in the figure.
Guide Disassembly Note
1. Place an alignment mark on the guide pin and flame.
2. Slide the guide to the rear of the sunroof frame, and remove the guide and decoration link as a single unit.
Guide Assembly Note
1. Move the pin to the position shown in the figure.
Decoration Link Assembly Note
1. Set the guide pin to the decoration link.