Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2007 >> MX-5 Miata L4-2.0L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Side Air Bag Sensor Removal/Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Side Air Bag Sensor Removal/Installation

SIDE AIR BAG SENSOR REMOVAL/INSTALLATION

WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the side air bag sensor.

1. Turn the ignition switch to the LOCK position.
2. Remove the battery cover.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove the quarter trim.
5. Remove the scuff plate.
6. Remove the tire house trim.




7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. Turn the ignition switch to the ON position and hold for 5 s or more.
10. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
- If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system.
pro multis · About Operation CHARM