Clockspring Assembly / Spiral Cable: Service and Repair

CLOCK SPRING REMOVAL/INSTALLATION

1. Remove the battery cover.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the following parts:
1. Driver-side air bag module.
2. Steering wheel.
3. Meter hood.
4. Column cover.

4. Remove in the order indicated in the table.






5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position.
7. Verify that the air bag system warning light illuminates for approx. 6 s and then goes out.
- If the air bad system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and inspect the system.

Clock Spring Installation Note

CAUTION: If the clock spring is not adjusted, the spring wire in the clock spring could over-wind and break when the steering wheel is turned. Always adjust the clock spring after installing it.

Steering Angle Sensor Removal Note






1. Detach the tabs at the four locations shown in the figure and remove the steering angle sensor.

1. Adjust the clock spring after installing it. (See CLOCK SPRING ADJUSTMENT.) Adjustments