Rear Washer Hose

REAR WASHER HOSE REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the mudguard (RH).
3. Disconnect rear washer hose A from the washer tank.




4. Remove rear washer hose A from clips A.
5. Disconnect joint pipe A and remove rear washer hose A.
6. Remove the following parts:
1. Front door.
2. Sail garnish.
3. Front scuff plate inner.
4. Front side trim.
5. Side panel (passenger's side).
6. Side wall.
7. Front console.
8. Glove compartment.
9. Lower panel.
10. Center panel module.
11. Climate control unit.
12. Car-navigation unit (with car-navigation unit).
13. Selector lever component.
14. Driver-side air bag module.
15. Meter hood.
16. Lower column cover.
17. instrument cluster.
18. Steering shaft.
19. A-pillar trim.
20. Rear heat duct.
21. Windshield wiper arm and blade.
22. Cowl grille.
23. Dashboard.

7. Remove rear washer hose B from clips A.
8. Disconnect joint pipe B and remove rear washer hose B.
9. Detach clips B.
10. Remove the following parts:
1. Front seat belt upper anchor installation bolt.
2. Rear scuff plate.
3. B-pillar lower trim.
4. B-pillar upper trim.
5. Rear package tray lid.
6. Sub-trunk.
7. Third-row seat.
8. Trunk end trim.
9. Rear header trim.
10. Third-row seat belt lower anchor installation bolt.
11. Cargo compartment light.
12. Trunk side trim.
13. Second-row seat belt upper anchor installation bolt.
14. C-pillar trim.
15. Map light.
16. Sunvisor.
17. Assist handle.




11. Disconnect joint pipe C.
12. Remove the headliner.
13. Cut the urethane of the headliner and remove the tape and rear washer hose C.

NOTE: After installing the rear washer hose, reinforce the urethane that was cut when removing.

14. Remove rear washer hose D from the rear washer nozzle.
15. Install in the reverse order of removal.