Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2008 >> 6 L4-2.3L >> Repair and Diagnosis >> Body and Frame >> Relays and Modules - Body and Frame >> Keyless Entry Module >> Service and Repair >> Keyless Control Module
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Keyless Control Module

KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS SYSTEM]

NOTE
- If the keyless control module is replaced, always perform the following procedure.
Without immobilizer system
- Card key programming (See CARD KEY ID CODE REGISTRATION [ADVANCED KEYLESS SYSTEM]. Card Key ID Code Registration
- Steering lock unit programming (See STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS SYSTEM]. Steering Lock Unit ID Code Registration

With immobilizer system
- Card key programming (See CARD KEY ID CODE REGISTRATION [ADVANCED KEYLESS SYSTEM].. Card Key ID Code Registration
- Steering lock unit programming (See STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS SYSTEM]. Steering Lock Unit ID Code Registration
- Immobilizer system resetting (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [ADVANCED KEYLESS SYSTEM].) Procedures

1. Disconnect the negative battery cable.
2. Remove the glove compartment.




3. Remove the bolt.
4. While inclining the keyless control module along the body panel in the direction indicated by the arrow, disengage the bracket tab from the hole in the body panel.
5. Disconnect the keyless control module connector.
6. Remove the keyless control module.




7. Remove the screw, then remove the bracket.

NOTE
- The screw which fixes the keyless control module and bracket is for a body ground connection. Be sure to secure the screw when installing.

8. Install in the reverse order of removal.
pro multis · About Operation CHARM