Water Pump: Service and Repair

WATER PUMP REMOVAL/INSTALLATION [L3, AJ]

L3






1. Disconnect the negative battery cable.
2. Drain the engine coolant.
3. Remove the drive belt.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add the engine coolant.

AJ

Part 1:

Part 2:

WATER PUMP REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Remove the air cleaner.
4. Drain the engine coolant.
5. Remove the water pump drive belt pulley.





Replace part A of the SST [303-009 (49 UN30 3009)] with the SST [303-457 (49 UN30 3457)].




Remove the water pump drive belt pulley using the SSTs.

6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.

NOTE:
Tighten the bolts to the specified torque, then tighten them further 85° - 95°.
Tightening torque: 10 Nm (102 kgf-cm, 89 inch lbs.)





8. Install the water pump drive belt pulley using the SST.
9. Add the engine coolant.