4WD

WHEEL SPEED SENSOR - FRONT, 4WD

Part 1:

Part 2:

Removal and Installation
1. Remove the brake disc shield.
2. Disconnect the negative battery cable.
3. Disconnect the wheel speed sensor electrical connector.
4. Remove the wheel speed sensor harness bolt and unclip the retainers.
^ To install, tighten to 8 N-m (0.8 kgf-m, 71 in-lbf).
5. Remove the wheel speed sensor bolt and the wheel speed sensor.
^ To install, tighten to 12 N-m (1.2 kgf-m, 9 ft-lbf).

Note:
^ Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply wheel bearing grease to the mounting surface.

6. To install, reverse the removal procedure.