Steering Angle Adjustment
Steering Angle Adjustment1. Loosen the locknut of the tie-rod end.
2. Remove the rack boot clamp.
3. Rotate the tie rod and adjust the steering angle.
Standard steering angle
Inner: 38°42'±3°
Outer: 32°54'±3°
Note:
^ Rotate and adjust the tie rod. The difference between the right and left dimension L shown in the figure should be within the specification.
Standard
3 mm (0.12 in) or less
4. Tighten the locknut of the tie-rod end.
Tightening torque
68.6 - 98.0 Nm (7.00 - 9.99 kgf-m, 50.6 - 72.2 ft-lbf)
5. Correct the rack boot deformation.
6. Install and fix the rack boot clamp.
7. After adjusting the steering angle, always inspect and adjust the total toe-in. (See Total Toe-in Adjustment.)