Windshield Washer Reservoir: Service and Repair
WASHER PUMP AND RESERVOIR REMOVAL/INSTALLATION1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING.
2. Remove the RH front fender splash shield.
3. Disconnect the washer pump electrical connector
4. Disconnect the front and rear washer pump hoses.
- Spread the clip apart to release the lock and pull the hose assembly from the pump.
- To install, make sure the hoses are fully seated and locked in place.
WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the washer solution container. Failure to follow these instructions may result in personal injury.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
5. Remove the 2 windshield washer reservoir bolts and the windshield washer reservoir.
- To install, tighten to 6 N.m (0.6 kgf.m, 53 in.lbf).
6. To install, reverse the removal procedure.
- Fill the windshield washer reservoir with windshield washer fluid.
WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.