Rear Window Wiper Motor Removal/Installation

REAR WINDOW WIPER MOTOR REMOVAL/INSTALLATION
1. Remove the rear pivot arm.
2. Remove the rear wiper motor shaft nut cover.
3. Remove the rear wiper motor shaft nut.
- To install, manually finger-tighten the nut, then tighten to 6 N.m (0.6 kgf.m, 53 in.lbf).

4. Open the liftgate window.




5. Remove the rear wiper motor cover trim panel.




6. Remove the rear wiper motor.
1. Disconnect the electrical connector.
2. Remove the 2 rear window wiper motor nuts.
1. To install, tighten to 7 N.m (0.7 kgf.m, 62 in.lbf).

3. Remove the rear window wiper motor.

7. To install, reverse the removal procedure.