Reverse Idler Gear Component, Reverse Shift Fork and 5TH/Reverse Shift Rod End Assembly Note

Reverse Idler Gear Component, Reverse Shift Fork and 5th/Reverse Shift Rod End Assembly Note





1. Shift the 3rd/4th shift fork to 4th.





2. Place the reverse idle gear component to the position shown in the figure.





3. Assemble the reverse shift fork to the reverse idle gear component, and point the reverse idle gear component thread hole outward.





4. After assembling the reverse shift fork, verify that the interlock sleeve end and control lever end are aligned as shown in the figure, and the reverse shift fork is engaged with interlock sleeve.





5. Point the 5th/reverse shift rod end bolt hole and projection outward as shown in the figure, and place the 5th/reverse shift rod end on the reverse shift fork through the 3rd/4th shift fork.





6. Assemble the 5th/reverse shift rod and tighten the bolts.

Tightening torque:
11.8 - 15.7 N-m (1.2 - 1.6 kgf-m, 8.7 - 11.5 ft-lbf)