Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2009 >> Tribute 2WD L4-2.5L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Technical Service Bulletins >> Customer Interest >> A/T Controls - Engine No Crank/DTC P0706/P0707/P1702
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

A/T Controls - Engine No Crank/DTC P0706/P0707/P1702

Bulletin No: 05-006/09

Last Issued: 04/24/2009

Subject:
NO CRANK - DTC P0706 / P0707 / P1702

BULLETIN NOTE
^ This bulletin supersedes the previous bulletin 05-013/08, issued on 11/21/08. The REPAIR PROCEDURE and WARRANTY INFORMATION has been revised.

^ Changes are noted below are shown with [NEW] and a black bar.

APPLICABLE MODEL(S)/VINS
2009 Tribute equipped with 6F35 six-speed Automatic Transmission built before Oct. 6, 2008

DESCRIPTION

Some vehicles may exhibit a no crank condition and/or DTCs P0706, P0707 or P1702. This may be caused by the output shaft speed (OSS) sensor wire being pinched between the main control and transmission case, or an intermittently shorted transmission range (TR) sensor.

Customers having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

NOTE:
TR code DTCs may be a result of poor common power and/or ground circuit shared between the TR sensor, OSS sensor and turbine shaft speed (TSS) sensor.

1. Verify concern.

2. Follow Workshop Manual (section PINPOINT TEST 4: TRANSMISSION RANGE (TR) SENSOR) through to step 9.

3. If cause has not been found by the end of step 9, unplug OSS connector from solenoid body lead frame.

4. Check resistance between transmission case and each of the three (3) OSS sensor wires one at a time.

5. If any one of the three (3) OSS sensor wires are shorted to ground (transmission case) less than 5 ohms, replace OSS sensor according to Workshop Manual (section 05-13 OUTPUT SHAFT SPEED (OSS) SENSOR REMOVAL/INSTALLATION).

NOTE:
Be very careful not to pinch the OSS sensor wires during installation of main control.

6. [NEW] If the OSS sensor wires are not shorted to ground, replace only the TR sensor according to the Workshop Manual (05-13 DIGITAL TRANSMISSION RANGE (TR) SENSOR REMOVAL/INSTALLATION). [END NEW]

7. Verify repair.





PART(S) INFORMATION





WARRANTY INFORMATION

NOTE:
^ This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.

^ This repair will be covered under Mazda's New Vehicle Limited Warranty term.

^ Additional diagnostic time cannot be claimed for this repair.


pro multis · About Operation CHARM