Transmission Position Sensor/Switch: Adjustments

TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [FS5A-EL]

CAUTION:
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1. Select the selector lever to N position.

2. Perform the following procedures.
a. Remove the battery cover. Removal and Replacement

b. Disconnect the negative battery cable.

c. Remove the air cleaner component. Service and Repair

d. Disconnect the TR switch connector.






3. Loosen the TR switch.
a. Remove the clip from the selector cable.

b. Disconnect the selector cable from manual shaft lever.






c. Loosen the TR switch installation bolts.






4. Adjust the TR switch.
a. Verify that the manual shaft is aligned with N position.






b. Adjust the TR switch between terminals B and C until the resistance becomes specification.






TR switch specification
- 713-788 ohms

c. Tighten the TR switch installation bolts.

Tightening torque
- 8-11 Nm {82-112 kgf-cm, 71-97 in-lbf}