Standard Deployment Control System

DTC B1057, B1916, B1932, B1934, B1936 [STANDARD DEPLOYMENT CONTROL SYSTEM]

System Malfunction Location





Detection Condition

WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

- Resistance other than 1.61-5.77 ohms detected in driver-side air bag module circuit
- Wiring harness between driver-side air bag module and SAS control module has malfunction

Possible Causes

- Clock spring connector malfunction
- Clock spring malfunction
- Open or short circuit or short to ground or short to power supply in the wiring harness between the clock spring and SAS control module
- Driver-side air bag module malfunction
- SAS control module malfunction

System Wiring Diagram





Diagnostic Procedure