Seat Track: Service and Repair

SEAT TRACK REMOVAL/INSTALLATION

1. Remove the front seat backrest. See Front Seat Backrest Removal/Installation.

2. Remove the safety belt buckle pretensioner.

- Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
- Detach the wiring harness pin-type retainer.
- Route the wiring harness from between the seat track and cushion frame.

3. Disconnect the electrical connectors, detach the wiring harness from the seat track.

- For the driver seat, disconnect the seat position sensor electrical connector.
- If equipped, disconnect the power seat motor electrical connector.
- Detach the seat harness electrical connector from the seat track.

- Note wiring harness routing for installation.

4. Remove the 4 seat track-to-cushion frame bolts.

- To install, tighten to 25 Nm {2.5 kgf-m, 18 ft-lbf}.

5. To install, reverse the removal procedure.

- Transfer components as necessary.