DTC Display

DTC DISPLAY

NOTE:
- If the self-test is implemented, the seat weight sensor calibration is performed. Perform the DTC inspection in accordance with the following conditions:

- Do not place objects on the front seat (passenger side)
- Do not touch the front seat (passenger side)
- Fix the slide position of the front seat (passenger side) to the maximum rearward position.
- Fix the recliner position of the front seat (passenger side) to the maximum forward position.
- Set cabin vehicle temperature range between the -10 to 40 °C {14 to 104 °F}
- Other than the above conditions, a "Japan only" command is also displayed, however, do not select the command because it is for use in Japan only.

1. Connect the M-MDS(IDS) to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
a. Select "Self Test".

b. Select "Modules".

c. Select "RCM".

3. Verify the DTC according to the directions on the screen.

- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4. After completion of repairs, clear all DTCs stored in the SAS control module. Clearing DTC