Cylinder Head Assembly
Cylinder HeadMeasure the length of each cylinder head bolt.
Replace any cylinder head bolts that exceed the maximum length.
Cylinder head bolt length
Standard 144.7-145.3 mm {5.697-5.720 in}
Maximum 146 mm {5.74 in}
Tightening procedure
Step 1 3.0-11 Nm {31-112 kgf-cm, 27-97 in-lbf}
Step 2 13-17 Nm {133-173 kgf-cm, 116-150 in-lbf}
Step 3 43-47 Nm {4.4-4.7 kgf-m, 32-34 ft-lbf}
Step 4 88°-92°
Step 5 88°-92°
Camshaft Bearing Cap
Install the camshaft caps and temporarily tighten the camshaft cap bolts evenly in two or three passes, and then tighten the camshaft cap bolts using the following two steps, in the order shown in the figure.
Tightening procedure
Step 1 5.0-9.0 Nm {51-91 kgf-cm, 45-79 in-lbf}
Step 2 14-17 Nm {1.5-1.7 kgf-m, 11-12 ft-lbf}
Exhaust Manifold Specifications
Intake Manifold Specifications
Camshaft Gear/Sprocket Specifications