ACCELERATOR PEDAL COMPONENT REMOVAL/INSTALLATION [WLT-1, WLT-2]

id011396807300

1.  Disconnect the negative battery cable.

2.  Set the power brake unit slightly out of the way. (R.H.D.) (See POWER BRAKE UNIT REMOVAL/INSTALLATION.)

3.  Set the clutch master cylinder slightly out of the way. (R.H.D.) (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION.)

4.  Remove the column cover and steering shaft. (R.H.D.) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)

5.  Remove in the order indicated in the table.

6.  Install in the reverse order of removal.

R.H.D.

absggw00000318

1
Neutral switch connector
2
Brake switch connector
3
Accelerator cable
(See Accelerator Cable Installation Note.)
4
Spring pin
5
Clevis pin
6
Pedal component
(See Pedal Component Installation Note.)

L.H.D.

absggw00000323

1
Accelerator cable
(See Accelerator Cable Installation Note.)
2
Accelerator pedal


Pedal Component Installation Note

•  Carry out the “BRAKE PEDAL INSPECTION” procedure after installing the pedal component. (See BRAKE SWITCH INSPECTION.)
•  Carry out the “CLUTCH PEDAL ADJUSTMENT” procedure after installing the pedal component. (See CLUTCH PEDAL ADJUSTMENT.)

Accelerator Cable Installation Note

•  Carry out the “ACCELERATOR CABLE INSPECTION/ADJUSTMENT” procedure after installing the accelerator cable. (See ACCELERATOR CABLE INSPECTION/ADJUSTMENT [WLT-1, WLT-2].)