DTC P1711 [5R55S]
id0502c1814200
|
DTC P1711 |
ATF temperature out of on-board diagnostic range |
|---|---|
|
DETECTION CONDITION
|
• ATF temperature range too high or too low during on-board diagnostic.
|
|
POSSIBLE CAUSE
|
• TFT sensor malfunction.
• TCM malfunction.
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY DTCS
• Turn the engine switch to the LOCK position, then to the ON position.
• Verify the DTCs in the TCM memory.
• Are DTCs except for P1711 output?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [5R55S].)
|
|
No
|
Warm or cool vehicle to normal operating temperature, then go to the next step.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF DTC P1711 COMPLETED
• Make sure to reconnect all the disconnected connectors.
• Clear the DTC from the memory using the IDS/PDS.
• Perform the “After Repair Procedure”.
• Are any DTCs present?
|
Yes
|
Replace the TCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY DTCS
• Are DTCs except for P1711 output?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [5R55S].)
|
|
No
|
DTC troubleshooting completed.
|
||