Flywheel removal (4JJ3 with DPD)

Part name

Tightening torque

3-1: 59 N・m { 6.0 kgf・m / 44 lb・ft }

3-2: 60 to 90 °

6: 18 N・m { 1.8 kgf・m / 13 lb・ft }

10-1: 59 N・m { 6.0 kgf・m / 44 lb・ft }

10-2: 60 to 90 °

Refer to "5.Transmission, Transaxle 5B.Automatic(AWR6B45) transmission removal".

Refer to "5.Transmission, Transaxle 5E.Clutch System(MVL) Clutch removal".

1. Manual transmission models

1) Install the special tool to the starter installation section of the rear plate.

SST: 5-8840-0214-0 - crankshaft stopper

2) Gradually loosen the flywheel mounting bolts in the order shown in the diagram, and remove the washer and flywheel from the crankshaft.

3) After loosening all of the bolts, remove the special tool and then remove the flywheel.

2. Automatic transmission models

1) Install the special tool to the starter installation section of the rear plate.

SST: 5-8840-0214-0 - crankshaft stopper

2) Gradually loosen the flywheel mounting bolts in the order shown in the diagram.

3) Remove the following parts from the crankshaft.