DTC P060B (Flash Code 36) Internal Control Module A/D Processing Performance (RZ4E-TC)

1. Engine control system check

Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) Diagnostic system check-engine controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to ECM replacement.

No

=>Go to Repair verification.

3. ECM replacement

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM removal".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM installation".

Refer to "1.Engine 1Z.Engine Electrical Control(RZ4E-TC) ECM setting".

Procedure completion

=>Go to Repair verification.

4. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool.