1. DTC P0336 description
The CKP sensor is installed on the top of the flywheel housing. There are 56 notches spaced 6° apart and a 30° opening on the outer circumference of the flywheel. Top dead center of cylinder No. 1 can be detected through this opening. The ECM monitors the signal pulses of the CKP sensor and the CMP sensor to make sure they correlate with each other. If the ECM receives excessive or short CKP sensor signal pulses, the DTC is set.
Each sensor signal waveform (When idling)
2. Condition for setting DTC P0336
Condition for running the DTC
- The battery voltage is 9 to 16 V.
- The ignition voltage is 9 to 16 V.
- The ignition switch is ON.
- The CKP sensor signal pulses are detected.
- DTCs P0335 and P0340 are not set.
Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC P0335 (Flash Code 15) Crankshaft Position Sensor Circuit".
Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC P0340 (Flash Code 14) Camshaft Position Sensor Circuit".
Condition for setting the DTC
- The ECM detects excessive or short CKP sensor signal pulses while the engine is running.
3. Action taken when DTC P0336 sets
- Euro4: The ECM illuminates the MIL. Refer to Action taken when DTC sets - Type A (Euro4).
- Except Euro4: The ECM illuminates the check engine warning light. Refer to Action taken when DTC sets - Type A (Except Euro4).
Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC type definitions".
- The ECM limits the fuel rail pressure.
- The ECM inhibits the cruise control.
4. Condition for clearing DTC P0336
- Euro4: Refer to Condition for clearing the MIL/DTC - Type A or Type B (Euro4).
- Except Euro4: Refer to Condition for clearing the check engine warning light/DTC - Type A or Type B (Except Euro4).
Refer to "51.Engine Control 1A.Troubleshooting(RZ4E-TC) DTC type definitions".