DTC P0631 (Flash Code 63) Control Module Programming Error (AWR6B45)

1. Transmission control system check

Refer to "55.Transmission Control 5A.Troubleshooting(AWR6B45) diagnostic system check-transmission controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to VIN writing check.

No

Go to Intermittent conditions of automatic transmission.

Refer to "206.Transmission, Transaxle 19D.Symptom(AWR6B45) Intermittent conditions of automatic transmission".

3. VIN writing check

1) Observe the VIN (Vehicle identification number) on the scan tool. Is the VIN (Vehicle identification number) written?

Yes

=>Go to TCM replacement.

No

Perform TCM programming.

Refer to "5.Transmission, Transaxle 5Z.Transmission Electrical Control(AWR6B45) TCM setting".

=>Go to Repair verification.

4. TCM replacement

Refer to "5.Transmission, Transaxle 5Z.Transmission Electrical Control(AWR6B45) TCM removal".

Refer to "5.Transmission, Transaxle 5Z.Transmission Electrical Control(AWR6B45) TCM installation".

Refer to "5.Transmission, Transaxle 5Z.Transmission Electrical Control(AWR6B45) TCM setting".

Procedure completion

=>Go to Repair verification.

5. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool.