DTC C1722[11] Side Right Turn Signal Light Output Circuit Short to Ground (BCM)

1. Body control system check

Refer to "64.Body Control 10I.Troubleshooting(BCM) diagnostic system check-body controls".

2. Current DTC check

1) Connect the scan tool.

2) Turn OFF the ignition switch.

3) Turn ON the ignition switch.

4) Operate the turn signal switch.

5) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Inspection for short to ground in side turn signal light (right) output circuit.

No

Go to Intermittent conditions of body control system.

Refer to "223.Body Control 36D.Symptom(BCM) intermittent conditions of body control system".

3. Inspection for short to ground in side turn signal light (right) output circuit

1) Disconnect the following harness connector.

2) Inspect the side turn signal light (right) output circuit between the BCM (pin 5 of B18) and the side turn signal light (pin 2 of C46) for a short to ground. Is the result normal?

3) Inspect the side turn signal light (right) output circuit between the BCM (pin 5 of B18) and the right outside rearview mirror (pin 12 of D4) for a short to ground. Is the result normal?

Refer to "LHD Body Control" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 with DPD)" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 without DPD, RZ4E)" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "LHD Body Control" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 with DPD)" in the ETM (wiring diagram). (Open using the ETM viewer.).

Refer to "RHD Body Control (4JJ3 without DPD, RZ4E)" in the ETM (wiring diagram). (Open using the ETM viewer.).

4) Are all of the results normal?

Yes

=>Go to BCM replacement.

No

Repair the circuit as necessary.

=>Go to Repair verification.

4. BCM replacement

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control BCM removal".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control BCM installation".

Refer to "9.Body, Cab, Accessories 9Z.Body, Cab, Accessories Electrical Control BCM setting".

Procedure completion

=>Go to Repair verification.

5. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Operate the turn signal switch.

5) Observe the DTC information with a scan tool.