DTC B1101[55] Vehicle Data Programming Not Complete (Stereo Camera)

1. Stereo camera system check

Refer to "75.Driver Assistance System 10W.Troubleshooting(Stereo Camera) diagnostic system check-stereo camera".

2. Current DTC check

1) Connect the scan tool.

2) Turn ON the ignition switch.

3) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Vehicle information programming.

No

=>Go to Repair verification.

3. Vehicle information programming

1) Perform the stereo camera programming.

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera setting".

Procedure completion

=>Go to Current DTC follow-up check.

4. Current DTC follow-up check

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool. Is a DTC set?

Yes

=>Go to Stereo camera replacement.

No

=>Go to Repair verification.

5. Stereo camera replacement

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera removal".

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera installation".

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera setting".

Refer to "9.Body, Cab, Accessories 9E.Instrumentation, Driver Info. stereo camera writing".

Procedure completion

=>Go to Repair verification.

6. Repair verification

1) Clear the DTC with a scan tool.

2) Turn OFF the ignition switch for 30 seconds or more.

3) Turn ON the ignition switch.

4) Observe the DTC information with a scan tool.