DTC P0089:00 [PCM (SKYACTIV-D 2.2)]
id0102j5008900
|
DTC P0089:00 |
High fuel pressure malfunction in common rail fuel pressure control system |
|---|---|
|
DETECTION CONDITION
|
• With the following conditions met, the actual fuel pressure exceeds 217 MPa {2,213 kgf/cm2, 31,473 psi} for a continuous 3 s.
Diagnostic support note
• This is a continuous monitor (CCM).
• The check engine light illuminates if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA/Snapshot data is available.
• DTC is stored in the PCM memory.
|
|
FAIL-SAFE FUNCTION
|
• Limits the fuel pressure. (High pressure)
• Limits the engine torque/limits the maximum engine speed.
• Inhibits the automatic diesel particulate filter regeneration control.
• Inhibits the manual diesel particulate filter regeneration control.
• Inhibits engine-stop by i-stop control.
• Inhibits the EGR control.
|
|
POSSIBLE CAUSE
|
• Fuel pressure sensor (integrated with fuel injector No.2) connector or terminal malfunction
• Fuel pressure sensor (integrated with fuel injector No.3) connector or terminal malfunction
• Fuel filter clogging
• Erroneous piping (poor connection) of fuel pipe
• Suction control valve malfunction
• Supply pump malfunction
• Fuel pressure relief valve malfunction
• PCM malfunction
|
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
Diagnostic Procedure
|
Step |
Inspection |
Results |
Action |
|---|---|---|---|
|
1
|
RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the freeze frame data/snap shot data.
|
—
|
Go to the next step.
|
|
2
|
INSPECT FUEL PRESSURE SENSOR
• Inspect the fuel pressure sensor.
• Is the fuel pressure sensor normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the common rail, then go to Step 8.
|
||
|
3
|
INSPECT FUEL FILTER
• Inspect the fuel filter for clogging.
• Is the fuel filter normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the malfunctioning location, then go to Step 8.
|
||
|
4
|
INSPECT FUEL PIPING
• Inspect the fuel piping.
• Is the fuel piping installation normal?
|
Yes
|
Go to the next step.
|
|
No
|
Install the fuel piping correctly, then go to Step 8.
|
||
|
5
|
INSPECT SUCTION CONTROL VALVE
• Inspect the suction control valve.
• Is the suction control valve normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the suction control valve, then go to Step 8.
|
||
|
6
|
INSPECT SUPPLY PUMP
• Inspect the supply pump.
• Is the supply pump normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the supply pump, then go to Step 8.
|
||
|
7
|
INSPECT FUEL PRESSURE RELIEF VALVE
• Inspect the fuel pressure relief valve.
• Is the fuel pressure relief valve normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the common rail, then go to the next step.
|
||
|
8
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Reconnect all disconnected connectors and hoses.
• Refer to the [MEMORY CLEARING PROCEDURE] and clear the DTC.
• Start the engine and warm it up.
• Stop all electrical loads. (Such as A/C, headlights, blower fan, rear window defroster)
• Drive the vehicle on flat roads under the following conditions 4 times repeatedly.
• Accelerate to 70 km/h and drive the vehicle while maintaining the speed for 60 s.
• Decelerate to 50 km/h and drive the vehicle while maintaining the speed for 60 s.
• Accelerate to 70 km/h and drive the vehicle while maintaining the speed for 60 s.
• Accelerate to 100 km/h and drive the vehicle while maintaining the speed for 30 s.
• Accelerate to 120 km/h and decelerate to 0 km/h.
• Stop the engine.
• Display the DTCs using the M-MDS.
• Has DTC P0089:00 been recorded?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
9
|
VERIFY OTHER DTCs
• Has any other DTC or pending code been stored?
|
Yes
|
Repair the malfunctioning location according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|