BRAKE LIGHT UNIT REMOVAL/INSTALLATION

id091800400000

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the following parts:

1.  Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

2.  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

3.  Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

4.  Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

5.  Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

3.  Disconnect the connector.

ac5uuw00004180

4.  Remove the bolt.

5.  Pull out the hook in the direction of the arrow shown in the figure.

ac5uuw00004181

6.  Remove the brake light unit.

7.  Install in the reverse order of removal.