CONDENSER INSPECTION [SKYACTIV-D 2.2]

id071100801334

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Discharge the refrigerant. (See REFRIGERANT RECOVERY.)(See REFRIGERANT CHARGING.)

3.  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

4.  Remove the front under cover No.1. (See FRONT UNDER COVER No.1 REMOVAL/INSTALLATION.)

5.  Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [SKYACTIV-D 2.2].)

6.  Remove the following parts:

(1)  Engine cover (See ENGINE COVER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

(2)  Air cleaner and fresh air duct component (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

(3)  Coolant reserve tank (See COOLANT RESERVE TANK REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

(4)  Cooling fan component (See COOLING FAN MOTOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

(5)  Charge air cooler inlet hose and charge air cooler outlet hose (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

(6)  Radiator (See RADIATOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

7.  Remove the condenser. (See CONDENSER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

8.  Inspect the condenser for damage, cracks, and oil leakage.

•  If there is any malfunction, replace the condenser. (See CONDENSER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

9.  Inspect the fins for restriction or foreign matter.

•  If any fins are restricted, remove the foreign matter. If there is any malfunction, replace the condenser. (See CONDENSER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

10.  Inspect the fins for bending.

•  If there is any bending, use the end of a flathead screwdriver to straighten the fins. If there is any malfunction, replace the condenser. (See CONDENSER REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)