SLIDE MOTOR INSPECTION

id091300800900

Warning

•  Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual before handling the front seat (side air bag integrated). (See AIR BAG SYSTEM SERVICE WARNINGS [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See AIR BAG SYSTEM SERVICE CAUTIONS [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

•  If the sliding mechanisms on both sides are not locked after assembling the front seat, the front seat will operate accidentally while the vehicle is driven, which could result in serious injury. After assembling the front seat, shake it up and down and verify that the sliding mechanism on the both sides are locked.

Caution

•  When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat.

Note

•  When removing the front seat from the vehicle or putting it back in, it can be performed smoothly by removing the headrest.

1.  Switch the ignition OFF (LOCK).

2.  Disconnect the negative battery terminal and wait for 1 min. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

3.  Disconnect the slide motor connector.

4.  Apply battery positive voltage and connect the ground to the slide motor terminals as indicated in the table below and verify the front seat operation condition.

•  If the operation cannot be verified as indicated in the table, replace the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)

Driver-side

ac8wzw00001192

Passenger’s side

ac8wzw00001193