TILT MOTOR INSPECTION

id091300811400

Warning

•  Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual before handling the front seat (side air bag integrated). (See AIR BAG SYSTEM SERVICE WARNINGS [TWO-STEP DEPLOYMENT CONTROL SYSTEM].) (See AIR BAG SYSTEM SERVICE CAUTIONS [TWO-STEP DEPLOYMENT CONTROL SYSTEM].)

Caution

•  When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat.

Note

•  When removing the front seat from the vehicle or putting it back in, it can be performed easier by removing the headrest.

1.  Disconnect the negative battery terminal and wait for 1 min or more. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)

3.  Partially peel back the front seat cushion trim. (See FRONT SEAT BACK TRIM REMOVAL/INSTALLATION.)

4.  Disconnect the front tilt motor connector.

5.  Apply battery positive voltage and connect the ground to the tilt motor terminals as indicated in the table below and verify the front seat operation condition.

•  If the operation cannot be verified as indicated in the table, replace the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)

ac8wzw00001197