POWER LIFTGATE (PLG) DRIVE UNIT INSPECTION

id091100003300

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2. Remove the following parts:

(1) Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(2) Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(3) Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)

(4) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(5) Bass box (with Bose^®) (See BASS-BOX REMOVAL/INSTALLATION.)

(6) Third-row seat cushion (See THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION.)

(7) Third-row seat back component (See THIRD-ROW SEAT BACK COMPONENT REMOVAL/INSTALLATION.)

(8) Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)

(9) D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

(10) C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(11) Assist handle (rear) (See ASSIST HANDLE REMOVAL/INSTALLATION.)

(12) Power liftgate (PLG) drive unit (See POWER LIFTGATE (PLG) DRIVE UNIT REMOVAL/INSTALLATION.)

3. Apply battery positive voltage and connect the ground to power liftgate (PLG) drive unit terminals G and H, and then inspect the front power window motor operation.

B+ Terminal

Ground Terminal

Operation

H

G

Liftgate close operation

G

H

Liftgate open operation

ac5wzw00010998

• If the power liftgate (PLG) drive unit does not operate as indicated in the table, replace it. (See POWER LIFTGATE (PLG) DRIVE UNIT REMOVAL/INSTALLATION.)