DTC P1705:00 [MZI-3.7 (PCM CONNECTOR (3 TYPES))]
id0102e4318900
|
DTC P1705:00 |
Transaxle range circuit not indicating Park/Neutral during self test |
|---|---|
|
DETECTION CONDITION
|
• The transmission range circuit does not indicate PARK/NEUTRAL during the self-test.
|
|
POSSIBLE CAUSE
|
• Gear selector not in PARK/NEUTRAL
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY THE SELECTOR LEVER POSITION
• Was the selector lever position in P or N position during the KOEO or KOER self-test?
|
Yes
|
Go to the next step.
|
|
No
|
Perform the KOEO or KOER self-test.
Then go to Step 5.
|
||
|
4
|
VERIFY STORED DTC IN TCM
• Verify stored DTCs in TCM.
• Are DTCs stored?
|
Yes
|
Go to the appropriate DTC inspection.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY TROUBLESHOOTING OF DTC P1705:00 HAS BEEN COMPLETED
• Verify that all disconnected connectors reconnected.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the KOEO or KOER self-test.
• Is the PENDING CODE for this DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|
||